Audi A6 E-tron due in early 2024
Range Rover Gives the 2024 Velar
New Panamera and Taycan to lead Porsche's EV future
MB Quart NA2-400.1 specifications.
Car amplifiers Specs << MB Quart << MB Quart NA2-400.1| Specification | | | Reviews |
General characteristics MB Quart NA2-400.1
Maximum Power:
400 Watts
Low Frequency Response:
50-150 Hz
Number of Channels:
1
Frequency Response:
10-300 Hz
Built In Crossovers:
Yes
Channel Separation:
No
Amplifier Class:
D
Fuse Rating:
30x1 A
MARINE GRADE PROTECTION:
YES
Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
PRE-AMP CIRCUITRY:
Q-Stasis Pre Amplifier Stage
The highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality
INPUTS:
2 Pair, RCA Nickel-Plated
High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
OPERATION MODE:
Mono operation
Deisgned to power 1 subwoofer or subwoofer system
CROSSOVER / SIGNAL SHAPING:
LPF
Complete control of amplifier signal, essential when using two or more amplifiers
CLASS / TOPOLOGY:
Full Range Class D
Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
OUTPUT DEVICES TECHNOLOGY:
PWM MOSFET Power Supply
Stable power through the PC board with minimal heat generation
HEAT SINK:
Aluminum
Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
POWER SUPPLY:
Simpatico Coil Design
The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
OUTPUT CONNECTIONS:
Quick Dissconect Wires, RCA Connections
Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
CONNECTIONS TYPE:
Nickel-plated connections
Nickel plated corrosion resistant connections
DIAGNOSTICS:
Three-stage protection circuits
Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
MARINIZED / WATERPROOF:
YES
Water resistant for durability in any environment
Class:
Full Range Class D
Variable Voltage:
0.2V~9V
Signal to Noise Ratio:
>100dB
Frequency Response:
10Hz-300Hz
CROSSOVER TYPE:
Electronic 12dB Per Octave
CROSSOVER FREQUENCY RANGE:
CH1 & CH2 | Switch Low Pass 300 Hz
Bass Boost:
0-12dB@45Hz
Subsonic Filter:
60Hz
POWER @ 2-OHMS:
1 x 400W
POWER @ 4-OHMS:
1 x 200W
Total Channels:
Mono
Audio Inputs:
RCA
Power Terminal 12v/gnd:
Molex 10 ga
Speaker Terminal Wire Gauge:
Molex Plug Connector
Fusing:
1 x 30 Amps
CERTIFICATIONS:
Marine & Powersports
Dimensions:
3.70 X 5.51 X 1.77 in | 9.4 X 14.0 X 4.5 cm
Weight:
2.09 lbs (0.95 kg)
Weight:
10
Popular today
Maximum Power: 2600 Watts; Low Frequency Response: 32-320 Hz; Number of Channels: 1; Frequency Response: 10-320 Hz; Built In Crossovers: Yes; RMS Power Output: 1000x1 Watts; Channel Separation: No; Am...
